Comments on: Nth Degree Makes Flat, Flexible, Printed LED Lights https://www.architerials.com/2012/02/nth-degree-makes-flat-flexible-printed-led-lights/ Materials matter. Sat, 29 Sep 2012 06:02:16 +0000 hourly 1 https://wordpress.org/?v=4.9.4 By: Lucy Den https://www.architerials.com/2012/02/nth-degree-makes-flat-flexible-printed-led-lights/comment-page-1/#comment-3505 Mon, 14 May 2012 04:59:21 +0000 http://www.architerials.com/?p=2247#comment-3505 Interesting! I don’t know much about this ink but seem it’s very interesting to apply. But being an ostrich is sounding very concerning and I think you should leave it initially to avoid the long term depression. Good luck for you.
http://www.justuno.com/

]]> By: Neil Shotton https://www.architerials.com/2012/02/nth-degree-makes-flat-flexible-printed-led-lights/comment-page-1/#comment-3452 Wed, 29 Feb 2012 16:04:52 +0000 http://www.architerials.com/?p=2247#comment-3452 The first product is a 2ft by 4ft light panel that will replace a four tube fluorescent fixture. The power supply is a little under two inches thick because: (1)code requirements and (2)it is powering 5000 effective lumens. The entire panel, including the power supply, is under 2 inches thick and weight 11.3 lbs.

A 200 lumen/watt LED requires a heat sink the size of a can of soup and they are expensive.

And awesome is what the first beta customer said about the ITO replacement ink.

The Nth team appreciates your comments

]]>